• Stops leaks fast.
• Makes tough, cured, epoxy repairs in as little as 90 seconds.
• Melts and cures in one operation.
• Restores service immediately.
• Effective for all refrigeration systems.
• Withstands pressure to 31 BAR (450 psi.).
• Resists temperatures to 175°C (350°F)
• Works on all metals, ceramics, even glass.
• Seals refrigeration systems using CFC's and HFC's, ammonia, and SO2.

DIRECTIONS.

1. Clean area by scraping or filing. Do not use steel wool. Area must be free of surface oil.

2. Apply 2" vacuum (65 mBar) to prevent oil from interfering with repaired epoxy.

3. Warm area with light flame and keep touching Heat-Seal Stik to area until the stick just starts to melt. Do not put flame directly on Heat-Seal Stik. Remove flame each time Heat-Seal Stik is touched to heated area.

4. Spread thin coating approximately 0,8 mm (1/32") over repair area using the stick end . Add adjacent heat to area if necessary so that stick spreads easily.

5. After application, heat to cure repair area as follows. Use LIGHT BRUSH flame and keep stroking flame directly on melted Heat-Seal repair for approximately one minute or until color changes to green brown color. CAUTION: Keep flame moving so that it does not char Heat-Seal. When properly cured Heat-Seal Stik has good adhesion and flexibility.

6. Repairs can be sanded and painted.